Visually this should look like same resolution monitors. So let's say we have two monitors 1440px and 1080px, cursor is leaving 1080px monitor at 950px position, 950 is 87.9% of 1080Ĩ7.9% of 1440 is 1265, so it should enter 1440px monitor at 1265px position. Would be nice if there was additional option, when enabled it would move cursor between monitors based on percentage of edge coordinates, (i.e.

This is very noticeable with physically same sizes monitors side by side, when you move cursor on the bottom of low resolution monitor it shows up higher from the bottom on high res monitor. The option Prevent mouse cursor from snagging on unaligned monitor edges works fine on monitors with different resolutions, with only one side effect: moving cursor from lower resolution would show it at the same Y coordinates, which is visually different relative to top/bottom on higher resolution monitor (only visually).